Hi,
I run FMLE 3.2 using FMLCmd but I have two problems
1) I use FMLECmd with /l switch to log to the file.
In general it works fine, but it looks like it is not logginig all output to the log file. For example, on FMLECmd I can see:
"More than 50 % of the specified threshold values (Max buffer size 512000 KB or Max buffer duration 3600 sec) of RTMP buffer reached. Current network conditions are unfavorable to publish data at the specified bitrate. RTMP buffer will be flushed and streams will be re-published when the threshold value is reached."
But I don't see it in the log file - it is missing.
How can I force FMLECmd to log everything to the log file that I provided using /l switch?
2) Regarding error in 1)
I use multiple bit rate.
After few hours on streaming, I get this error:
"More than 50 % of the specified threshold values (Max buffer size 512000 KB or Max buffer duration 3600 sec) of RTMP buffer reached. Current network conditions are unfavorable to publish data at the specified bitrate. RTMP buffer will be flushed and streams will be re-published when the threshold value is reached."
On the output, under Publishing section I can see that Buffer value is growing, till it reach 3600 sec and stream session is restarting.
During this time, I cannot watch my video stream.
My questions are:
- Are this max buffer vlaues set on the FMLE site or RTMP server?
- if on the FMLE site, where can I change it? which section in profile.xml is responsible for that?
Regards